0 Members and 1 Guest are viewing this topic.

*

Offline Arizona Bushman

EPS question
« on: November 23, 2023, 08:54:22 PM »
During a ride today the eps went out, fortunately it was near the end of the day. My friends an I looked things over and did not see anything obvious with the wiring harness or steering gear. I was about to load it up when it began to work again. Apparently, one of my crew manipulated the wiring a little and I guess it was enough to re-establish a intermittent connection. I understand that questionable connections can be the source of this problem, but is there any particular ones I should look into first?
Had a 2017 Zforce 800EX, traded to a 2020 Uforce 800

*

Offline Arizona Bushman

Re: EPS question
« Reply #1 on: December 09, 2023, 08:41:29 PM »
Any at all?
Had a 2017 Zforce 800EX, traded to a 2020 Uforce 800

*

Offline NMKawierider

Re: EPS question
« Reply #2 on: December 10, 2023, 10:22:14 AM »
Check the EPS motor fuse holder..not the fuse itself. CFM has had a lot of issues with main fuse holders having bad internal connections that act the same as you describe. Otherwise the EPS controller can and will cut out when hot until it cools down.
2015 Z Force 800 53/Trail EPS
Custom Air Intakes | Custom Exhaust Mod | SuperATV Harness | Custom Fenders | Custom Skid/Rock Sliders | 27" GBC Grim Reapers | Seizmik Mirrors |Конструктор Doors | Dr Pulley Sliders | 1.5" Wheel Spacers | BENZ Silencer (as needed) | SATV Flip Windshield W\ Rear Shield | Dual Light Bars | Diamond Plate Storage |7- 9.7" GPS Systems | Bandit Springs Rear & Gen-3 Shocks Front | Cage Chop Mod

My Videos On YouTube