I am trying to find a schematic for the plug and play hook up for the ZForce 1000 to add turn signals to my Moto. When I look by the fuse box there are 3 - 9 pin connection blocks there. One is a red block, and the other two are white blocks. None of them have anything plugged into them. Does anyone here no how to connect the turn signals up and add all of the switches for turn signals and hazard flashers.

[2015 Z Force 800 53/Trail EPS]

I am trying to find a schematic for the plug and play hook up for the ZForce 1000 to add turn signals to my Moto. When I look by the fuse box there are 3 - 9 pin connection blocks there. One is a red block, and the other two are white blocks. None of them have anything plugged into them. Does anyone here no how to connect the turn signals up and add all of the switches for turn signals and hazard flashers.

I sure don't but I took a quick look at the wiring diagram in the service manual and it's all there. It is listed as optional so it's not actually "Plug-n-Play" but an optional system. Page 306. It's all there. Have fun.   Here's a link so you can download it:

https://documentcloud.adobe.com/link/track?uri=urn%3Aaaid%3Ascds%3AUS%3A55bf88d0-d980-472a-88c0-c832b8531fcd

I've not seen one up close, but the website indicates that the 1000 body is the same as the 800.

If that's the case, you should have pigtails for directionals floating around above the front wheels, and the back light wiring is already wired for directional signals.  Just add the front lights, swap out the back lights, and add the dash switches to the existing plugs under the switch panel. The lights and switches should be available from the cfmoto dealer.

Is there any current information on how to install turn signals on a 2019 ZForce 1000?  How can I get a Service Manual?

The short answer is no. The service manual won't have that procedure.

The long answer is that it should be pretty simple. Bolt on the front signals and plug in. Swap out the tail lights and plug in. Install the switches in the dash and plug in. Install the flasher if necessary.

Took about an hour on my '17 Z.

I wrote this up at the time:

http://cfmoto-forum.com/800ex800/adding-turn-signals/msg18767/#msg18767

I have swapped out both rear tail lights.
I have installed both front signal lights.
I removed the lower dash cover as you suggested.
I have removed the plastic plate in the signal switch opening.
I have found a matching jack for the signal switch.
I am having a problem finding what/where the flasher plugs in.  Should there be a cable jack up in this same area?
I do not understand what the "Cushion Flashers" are for.
Thanks again for any assistance you can provide.

jerry

The flasher came installed from the factory on my Z. I just slapped in the switch and it worked.

I would suspect that the flasher would  install near the rest of the relays, but might already be there. I never located mine so I can't help there.

Check all the connectors under the dash to see if there is more than one that would fit the switch.

Cushion Flashers???