Well, not a great start. Bought 2022 UForce 1000 March 2%u2026. Put it away as was taking to our place in the north. Put on the included trickle charger a couple times%u2026 in  late May 28th, took it up north and dropped it in garage there%u2026. Rained terrible so didn%u2019t take it out.

Finally had our first weekend. Starts right up, and I go to heat cycle the belt. Odom from 2 miles to 6 miles%u2026 shut it off for belt  to cool for an hour. Starts right up again, hit 8 miles%u2026%u2026. Solid engine / EFI light%u2026.. sweet.

So have disconnected battery, full charging on computer controlled charger.

Hoping it resets and all is good. I%u2019ve read others with this occurring early on, and seen good and bad.

I%u2019ve pulled all the fuses in front and checked them. Battery posts were tight.

Ugh%u2026.

[2015 Z Force 800 53/Trail EPS]

It's new...Take it in!

Selling dealer is 180 miles away...and I'm in the middle of moving is the wrinkle... I have the wrong trailer with me. (Sold my house where I bought it... able to work anywhere, so why not where I can fish and drive my Uforce on thousands and thousands aid acres?)

It will go in if needed.

[2015 Z Force 800 53/Trail EPS]

Doesn't have to be the selling dealership. Any authorized CF Moto shop can take care of it.

I understand it doesn't have to be the selling dealer, but the closest one is 85 miles....the wrong direction for heading to our house downstate.

Re: the issue... battery was already showing 90% when I put on a charger, and it topped off pretty quick even at just 6 amps.

Reinstalled to the UF1000 and coated the posts.

Started right up, and after about 30 seconds, EFI light went out. Drove 4 miles, stayed out. Hopefully it was just a fluke, and not a returning gremlin.

Have to replace a bolt that was installed cross threaded, and left only half-way in  by either the factory or dealer for the front skid plate.

Looking forward to running this rig.

Hi, I have the same problem. The EFI light turns on and stays solid. I was able to turn it off detaching th battery for an hour, it doesn't work always. The light also turns off in same cases if I don't use the uforce for 1-2 days.
I bought a obd2 reader and fount the problem is error code P0108, I asked my reseller some information but still waiting.

I also notice the the light turns on when I use 4WD if I use only rear traction everything is ok.

Hope this helps in some way

Cristian

[2015 Z Force 800 53/Trail EPS]

Here's a list of fault coded for the newer ones.

I was able to solve this issue leaving the Uforce for 1 week at the dealer. They checked the whole electrician system and found a connector that wasn't correctly crimped. Now all is ok