Hey all. I have a 2021 UForce 1000 with about 5000 kms on it. Its been a great machine except for this issue. After a long drive, usually over 100 kms I will be driving at a steady spped and the throttle acts like it goes to an idle. If I press it further, nothing happens, but if I let off, and push the throttle again, it comes back to normal, sometimes for only a couple of seconds and sometimes for a few minutes. I replaced the throttle pedal and it worked great for about 800 kms and now the issue has returned. Any ideas?

[2015 Z Force 800 53/Trail EPS]

They did have a lot of issues with the electronic throttle module. It may have just gone bad again. 

Well that doesn't sound good. Is there no fix for the pedal?

[2015 Z Force 800 53/Trail EPS]

Well that doesn't sound good. Is there no fix for the pedal?

Sure. If the problem is either electronic peddle or throttle body step motor, getting a good one is the cure. But after looking at two places I can't tell if this even has an electronic peddle or manual as I can't fine the peddled, modules or even cables. Take a pic of your peddle assembly and post it. If it is, it's either that or the step motor on the TB.

The pedal is definitely electronic. I actually replaced the throttle body first and it made no difference. I was wondering if the pedal could be repaired.

[2015 Z Force 800 53/Trail EPS]

The pedal is definitely electronic. I was wondering if the pedal could be repaired.

None have ever been..just replaced.