Good morning,

My Snyper 600 2013 runs great when I start it and after 5-10 minutes as the engine warms up it shuts off. I restart it and when I press the accelerator it does not increase in rpm like a cut off.

Do you have idea of the problem?

Thanks

Update

I had the gears manually engaged to see where the problem is.

On several occasions when I change a speed the teeth of the gear embarks to put it in speed and then by turning it comes out of the gear.

What would be the problem? Springs too soft?

Thanks for your help

I reopened the engine I have the impression that the problem is due to the fork spring which is too soft

Hello, I rebuild a snyper 600 engine it works great. The problem is that I am unable to engage it on high or low. He only does neutral and backwards.

Where is the problem I leave pictures of the interior

I need help thanks

I can always reopen my engine even if I believe that inside everything is correct and installed the final shifter before closing.

I'm not sure I understand... I know I'm off by a tooth in the photo. But I tried a lot of patterns. I closed the engine block. I want to be sure that I am correct before going too far.

Hello, I am currently rebuilding a 2013 snyper 600 engine.
I have a question about the gear clutch outside the engine block. My question is it normal that I am able to go to the end of my teeth on one side only? (see photo to understand). I feel 3 gears when I manually engage. Thank you for your help.