Hello all, new to the forum, hope someone can help me out here. I have a 2021 CForce 500, been a fairly flawless machine since I purchased it new in Oct 2020. It%u2019s been sitting idle in my garage with a broken rear fender for 6 months. I have cranked it here and there, but it%u2019s been over a month since I tried to start it until today. It took 6 months to get my new fender, today was my day to put it on. So I tried to crank it before disassembling the rear. Dashboard came to life, could hear the fuel pump, but starter just clicked when I tried to start it. I figure no big deal, I have to pull the battery anyway to replace the rear fender. So I pull the battery, put it on a battery tender trickle charger, for roughly 3 hours (tender green light was flashing which indicated battery is around 80%). Long story short, I get the fender replaced, everything back together, I go to try and start the machine, my dashboard lit up but with nothing except a line across it, could not hear the fuel pump, headlights do not work, hit the start button & nothing happens. ALL I did (electrical wise) was remove the battery & unplug the tail light. I%u2019m at a loss here, I went back and looked for a pinched wire, I see nothing. I messed with nothing electrical. I have used to the battery tender before on this machine & never had a problem. Does anyone have any ideas? Battery terminals are correct. Just seems so odd because it would have started before I started work had the battery been charged.