[Ecosta]

Hey guys.  Emanuel here from Ontario.

Finally picked up my 2017 Z8 and was able to take it on the trails the same day 😁

[ctdls]

Sweet ride! Welcome 

[Ecosta]

I got the rood and half windshield for now. Might go with metal doors after. So far so good. Still trying to figure out how to break in the engine. I did 30km yesterday and tried not to go over 5k rpm. Very happy with it. Suspensions how it handles etc. I had dirtbikes and atvs all my life, this is my first sxs.

[vman]

Sweet...let the fun begin.

[Moto_Man63]

Glad you took the bow off before you went riding

[Ecosta]

First mod on the Zforce


Little 3l spare gas container

[Ecosta]

Now i got my led light bar that im gonna start installing. Should i just get power straight from battery or is there somewhere better?

[NMKawierider]

Now i got my led light bar that im gonna start installing. Should i just get power straight from battery or is there somewhere better?

Depends on how much power the bar needs and..if there is anyway the light can be turned on and forgotten about. Mine uses about 4 amps so I used the accessory power wire to the receptacle. Its keyed..meaning when the key is off, there is no power...and its on a 10 amp fuse. If yours uses much more, then its may be best to come from the battery with a fused supply but I would recommend using a relay that's triggered by that accessory wire so it too will kill power when the key is off.   

[Jeff]

Where in Ontario? I’m in New Hamburg

[Ecosta]

Im from Aurora north of Toronto

[Ecosta]

So today i finished my led light bar switches and back up lights. Wasnt easy to drill thru a brand new dash but the end result was good 😁

[vman]

Looks good, nice installation, I saw the first pic and thought you were going to leave the decal on.

[gfmoto]

Lol v man, thought the same thing.  Good call leaving it on during drilling/ cutting so it protected the finish.   Nice looking install!

[Ecosta]

Thanks guys. I considered taking the turning signal and 4 ways buttons out and put these two there so i wouldnt have to drill anything. But decided to keep everything.

[Ecosta]

Wont have problems with lights now 😁