Looking for some transmission help, took the gear shift cover to to the motor off to tighten the bolt and spring, went through the gears manually and went I click past low and now is stuck in gear and can't realign the cover and gears, any help would be deeply appreciated, thank you.

[2015 Z Force 800 53/Trail EPS]

What unit is this?

2018 800 trail, thank you

[2015 Z Force 800 53/Trail EPS]

Sorry, I haven't run into that problem before. I can only assume that one must reverse the actions that put it in this position. You may need to remove all the upper parts, find neutral, then reset the parts. Lets hope the barrow and the detent are not effected. Otherwise it may be a full tear-down.

Thank you very much, fingers crossed