I just bought a 2022 CForce 600 (single seater). Can anyone tell me how to go about wiring/installing/connecting an LED lighted license plate frame? Thanks.

[2015 Z Force 800 53/Trail EPS]

Just mount it where you can back there, ground it to any part of the frame and power it with the tail light power supply wire. Cake.

I pulled off some of the rear plastics and found these harnesses behind the tail lights. The two on the left don't seem to be used for anything. Think I can get the appropriate harness connector and connect the plate frame wires on to one of these? I'm guessing the yellow plugs connected now are just to keep water out?

You can do just that, if you can find the correct connector.

If somebody knows the name of these kind of connectors, used in cfmoto harnesses or place to buy them I also would like to know.

I contacted Digi-Key and a few others in the US and none of them recognized the connections for the CF-Moto.

You can do just that, if you can find the correct connector.

If somebody knows the name of these kind of connectors, used in cfmoto harnesses or place to buy them I also would like to know.

Eureka! I found this site (https://connectorexperts.com/) and they have pretty much the identical 2 pin male connector (their part# is CE2387F) I showed in the pic above on the far left, with the yellow seals. I just had them tell me what terminal fit's inside of it (part# TERM185). I placed an order and should have it in less than a week. I'll update after I get the parts.