Hi there just purchased a 2019 Quadzilla x8 uk spec, how many grease nipples are there and where are they located ?

Thanks

Stuart

[2015 Z Force 800 53/Trail EPS]

Welcome. Not sure for your version but most CFMs only have grease fittings on the upper and lower a-arms and the rear knuckles.

Welcome. Not sure for your version but most CFMs only have grease fittings on the upper and lower a-arms and the rear knuckles.

Thanks for your reply, I think my model is the CF820LE, I will look for the grease nipples tomorrow

I decided to check my fittings yesterday on my 1000 yesterday, I t was suggested to me that as a new machine the dealers do not always fully service them.

Anyway I counted 14 and replaced them with Brass Fittings, 6mm which I purchased on Amazon and used a Marine based grease in place.
I was told there are 16 total, but did not locate the other two.

I decided to check my fittings yesterday on my 1000 yesterday, I t was suggested to me that as a new machine the dealers do not always fully service them.

Anyway I counted 14 and replaced them with Brass Fittings, 6mm which I purchased on Amazon and used a Marine based grease in place.
I was told there are 16 total, but did not locate the other two.

The front has 4 (inner A-arms 1 top and bottom each side) the rear has 12 (4 outer A-arms top and bottom each side, 6 inner A-arms, 1 top and 2 bottom each side), the the two on the rear sway bar. hope you find them!

Thanks a lot that helped big time!

Hi all,
My model is a CF800AU-2B year 2019 and I can only find 4 grease nipples ..... do I need to keep looking ?

Thanks

Stuart

[2015 Z Force 800 53/Trail EPS]

Hi all,
My model is a CF800AU-2B year 2019 and I can only find 4 grease nipples ..... do I need to keep looking ?

Thanks

Stuart

All the a-arms, rear knuckles and maybe sway bar.

check the drive shaft really really good as well!