[574cfmotorider]

Hey guys,

Looking to replace my front and rear wheel hub bearings on 2021 zforce500.  You'd think that all years and models are the same.  However, part number for the rears are 3049903081 but the part number for the fronts are 9GQ0-050710 and only lists a few models in 2021 compatible.  Is this just a different part number that superseded another?  Reason I'm asking is I'd like to get a non cfmoto bearings for better quality and to save money and wondering if the ones listed on this forum for earlier years zforce800's would work with this (duralast dl513022 or DAC3055W).

https://cfmotousaparts.com/product/bearing-hub-cfmoto-oem-9gq0-050710/

[NMKawierider]

Man I wish I knew. For me when the time comes I'll just pull them and head to my local bearing supplier and let them take the measurements and find a match. Hopefully a National or Timken cross match.

[mpgo4th]

Hey guys,

Looking to replace my front and rear wheel hub bearings on 2021 zforce500.  You'd think that all years and models are the same.  However, part number for the rears are 3049903081 but the part number for the fronts are 9GQ0-050710 and only lists a few models in 2021 compatible.  Is this just a different part number that superseded another?  Reason I'm asking is I'd like to get a non cfmoto bearings for better quality and to save money and wondering if the ones listed on this forum for earlier years zforce800's would work with this (duralast dl513022 or DAC3055W).

https://cfmotousaparts.com/product/bearing-hub-cfmoto-oem-9gq0-050710/

I just looked them up for my 2021 800EX and I got the same numbers. I’d just they are the same as most. I do like the idea of pulling them and having them matched up by a competent shop. My parts store is good at that.

[glenlivet]

I replaced my '17 Z800 trail wheel bearings last year.
3 were shot at 10,000Km
 Fronts were 30499-03080, rear 30499-03081
That's rear DAC3063W, front DAC 3055W

I don't know about that 9GQ number

ps I found that the right front spindle nut was quite loose although the cotter pin was in place and intact. Could not have 'come loose', must have been loose from the factory. Somebody needs a slap.