[Tordesil]

Both rear A-arms are touching the wheels, what could be the problem?

[NMKawierider]

If not the wrong wheels, then look to the ball joints and/or wheel bearings. Probably need to give that thing a good cleaning to see anything...lol

[Workhardplayhard]

Has anyone flipped the hubs? I started to flip mine to get a little over 1" lift but it was rubbing the wheels like that so I didn't run it that way.

[Tordesil]

Has anyone flipped the hubs? I started to flip mine to get a little over 1" lift but it was rubbing the wheels like that so I didn't run it that way.

Ofcourse... how come I didn't think of that on my own. Especially that they were changed a few hundred km ago. You might be my saviour. So the "shorter end" of the hub should be facing up?

[Workhardplayhard]

Has anyone flipped the hubs? I started to flip mine to get a little over 1" lift but it was rubbing the wheels like that so I didn't run it that way.

Ofcourse... how come I didn't think of that on my own. Especially that they were changed a few hundred km ago. You might be my saviour. So the "shorter end" of the hub should be facing up?

Correct. The short side goes up. With them flipped over it'll give you about 1.5" lift. But rubs the wheels. So the cure is to put it back to stock stance or buy larger wheels.