Anyone know how to clear the MIL4 light from flashing .It has been doing it since I had the exhaust off to repair it AGAIN .When I did this I unplugged the O2 sensor and had the key turned on a couple times to check something else so I am guessing the that it what set the code. In the manual it says it will blink if fuel system trouble or history error codes not erased . Hate to have to take to dealer just to clear code . By the way it is a 2016 zforce 500 . Thanks

[2015 Z Force 800 53/Trail EPS]

Anyone know how to clear the MIL4 light from flashing .It has been doing it since I had the exhaust off to repair it AGAIN .When I did this I unplugged the O2 sensor and had the key turned on a couple times to check something else so I am guessing the that it what set the code. In the manual it says it will blink if fuel system trouble or history error codes not erased . Hate to have to take to dealer just to clear code . By the way it is a 2016 zforce 500 . Thanks

These don't save/store error codes like vehicles.. If it's flashing, a problem still exists. Once its is corrected, it stops.

Thanks guess I will have to try to figure it out  Sorry I guess I posted in wrong location

[2015 Z Force 800 53/Trail EPS]

Thanks guess I will have to try to figure it out  Sorry I guess I posted in wrong location

No problem. Hay the manual tells how to make it flash the code...then you can look it up. Do you need a service manual?

I dont have a service manual

[2015 Z Force 800 53/Trail EPS]

I dont have a service manual

PM sent...now you do.

Thanks that will help