My doors and pockets came today . They are absolutely the nuts .. I love them.

[2015 Z Force 800 53/Trail EPS]

Yeah..very nice.

Finally put the doors on.  The passenger side came out perfect, drivers not so good.  I do not like the way the top of door fits nice but lower door sticks out.  Ive shimmed , pulled, lots of grinding, pushed and lots of cussing and still am not satisfied. The whole door needs to twist from top to bottom in. I may have to perform surgery on the door support to align it better..lol.

Finally put the doors on.  The passenger side came out perfect, drivers not so good.  I do not like the way the top of door fits nice but lower door sticks out.  Ive shimmed , pulled, lots of grinding, pushed and lots of cussing and still am not satisfied. The whole door needs to twist from top to bottom in. I may have to perform surgery on the door support to align it better..lol.

I have the same problem with my driver door, spacing doesn't seem right. Didn't bother me on last few rides though. I think this winter when I have more time, I will take it back apart and work on the mounting points. I just need around an 1/8 of an inch and it will look just fine.

My doors and pockets came today . They are absolutely the nuts .. I love them.

Hi! can you send me some photos, it looks like your zforce now with doors!? mail [email protected]
You're the only one in the world who have installed these doors with this graphics!!! Should look amazing! I'm waiting for my friend!

new photo

Aw Mr. Roden posted my doors.... Everyone that has seen them luv them. They drool over the pocket liners.lol

Finally put the doors on.  The passenger side came out perfect, drivers not so good.  I do not like the way the top of door fits nice but lower door sticks out.  Ive shimmed , pulled, lots of grinding, pushed and lots of cussing and still am not satisfied. The whole door needs to twist from top to bottom in. I may have to perform surgery on the door support to align it better..lol.

If you don't like the way the doors were installed and they sit crooked, so you don't end up made an adjustment! Still need to adjust! I myself have often ustanavlivat door! and if you make all the adjustments, the door stand perfectly! All doors are the same, eliminated the differences!!! here in the forum there are instructions in English!
http://cfmoto-forum.com/russian-accessories-for-zforce-800-(rodin-nickolay)/quick-write-up-on-installing-the-doors/

Been there and done that,  I did get them to fit . Im all set now, i massaged the middle and bottom brackets and elongated the top roll bar bracket a little more toward the front so it would pull the whole assembly back and enable to twist the bottom in for a better alignment of front.  I in turn went and re did the passenger side same way.   

Now do you make a half door that the bottom is open and will fit the hinge's on the door brackets for the full doors? I think id like the option of swapping out doors for other driving conditions and still have a arm rest ..