What sort of speeds are you guys getting for your 600's?

55 with a good flat run is pretty common.  That Is with myself and my wife in the rig.  I'm a big guy at 300+

55 sounds about right.

53 was my top speed so far but I've never really left it wide open for very long.

55 is it

Ok issue guys everyone is getting 55 on there 600 ex, I hit 30 an mine hits Rev limiter

[2015 Z Force 800 53/Trail EPS]

Ok issue guys everyone is getting 55 on there 600 ex, I hit 30 an mine hits Rev limiter

Then either someone had over-clocked the secondary or the limiter is getting the wrong signal. What is the RPMs when it stops increasing?

Idk I can't see the rpms, how do I change it to see them. Plus it just started that this week

Push the left button below the dash until you see the rpm

Push the left button below the dash until you see the rpm

it only has a red button an that changes the time

Unfortunately, the 600's don't show RPM.

I was thinking about putting a induction type RPM gage on mine.

I'm just confused as how I went from hitting 42 an still going to hitting 30 then reving out.

[2015 Z Force 800 53/Trail EPS]

I'm just confused as how I went from hitting 42 an still going to hitting 30 then reving out.

If it's still hitting the same RPMs then the only thing that can change is gear ratio...and the only thing that can change is the belt. Transmission, diff and gearbox are hard gears so they will not change. Only the belt or something with the clutches can change so.. check them.

I pulled the belt box off bc I was on a incline this weekend and I feel that the belt pop/slip hard an so ever since then is when it's been topping at 30, how would I check all that?