Any one have issues with this?  it caused
y speedometer to only show a value of 0km/ mph, even when moving. the rpm limited to 5000rpm

code p050129.

i reset it via my scanner. it came back.  reset again..
worked ok for a few km.. went to rpm limitation again.
not sure why it now works ok...then goes into a limp type mode,...no speedometer function, then back to limp mode performance.

i was thinking it happened after going
thru a minor water puddle...
iis it possible that water or dirt is causing the issue.? any idea where in the console it is connected? i will try and attach a video or picture.

[2015 Z Force 800 53/Trail EPS]

The actual vehicle speed sensors on the older ones were mounted on the outside of the engine case on the front side where many did have a problem with water and other issues. Looks like they still do put it there. I would look there first if my display didn't register any motion when in motion. Who knows what effect that would have on the ECU if that data was cut off. P050129 isn't in the list I have but P050100 is and stated it's the vehicle speed sensor and effects mileage and performance which it likely mean it sets-off a limiter. 

The actual vehicle speed sensors on the older ones were mounted on the outside of the engine case on the front side where many did have a problem with water and other issues. Looks like they still do put it there. I would look there first if my display didn't register any motion when in motion. Who knows what effect that would have on the ECU if that data was cut off. P050129 isn't in the list I have but P050100 is and stated it's the vehicle speed sensor and effects mileage and performance which it likely mean it sets-off a limiter. 

thank you for the excellent info!!
is this a difficult part to replace?

i need to find.out where the sensor plugs in near the gear selector b4 i attempt to replace.

here is the video of it in action;

https://youtube.com/shorts/4ZTtuBZ9P-c?si=_nuJxaA9LleLC4YK

[2015 Z Force 800 53/Trail EPS]

On 2015 Z800 if I pull the seats and back plastics...or if I drop the main skid plate.. it's easy to get to. You might just find something in there between the sensor of the rotor. Also common.

thanks for the advice!!

On 2015 Z800 if I pull the seats and back plastics...or if I drop the main skid plate.. it's easy to get to. You might just find something in there between the sensor of the rotor. Also common.

the plug came out without much effort.
looks like some fluids were here...not sure if it was supposed to be easy to unplug. 

..and here is another picture of the end of the sensor i unplugged

[2015 Z Force 800 53/Trail EPS]

Be sure to flush it out with spray contact cleaner. Don't want any BS inside. Does it work now?

Be sure to flush it out with spray contact cleaner. Don't want any BS inside. Does it work now?

started, ran fine.   i am waiting to road /trail test it. 

there isno way that connectir is meant to pull off without depressing the metal clip.

it did the 5000rpm and no read out briefly....then engine light came on...with speed sensor code.   however, i kept driving it, and the started working as per norm.
S peedometer worked full on...and no more 5000rpm limitation has happened.   code dissappeared off the screen.   i think the ecu is learning again?  seems to now be working normal. 
i will still be taking it in for warranty check.  i won't be clearing anything until they check it out.

.

[2015 Z Force 800 53/Trail EPS]

Good.

Good.

annnndd....its back. 
same code, same issues. 
trailering it to the dealer.  i give up.  lol.

[2015 Z Force 800 53/Trail EPS]

At least you tried..