I have a 2020 UForce 500.  I just recently have experienced the EFI dash light and when trying to start the machine it just clicks when turning it over.  I thought maybe it was the battery but it has a full charge.  Any ideas?  How do I go about fixing?  Any help is much appreciated.

[2015 Z Force 800 53/Trail EPS]

A clicking starter relay is usually caused by low power and that can be from a bad or weak batters or a poor cable connection or any connection in line even a bad ground. It can also indicate that the engine is seized but if you remove the belt cover and rotate the primary by hand that can be eliminated. It could also indicate the starter has a problem but start with checking all the connections first....and do make sure the battery is good...there have been an abnormal number of battery failures recently.

Thanks so much for your quick response.  I will try to disconnect the cable, clean them up and reconnect.  Will try to purchase a new battery as well to se if it works.

[2015 Z Force 800 53/Trail EPS]

Thanks so much for your quick response.  I will try to disconnect the cable, clean them up and reconnect.  Will try to purchase a new battery as well to se if it works.

Just charge and have the battery load tested...it may be OK.