Good news for the 2023 owners when it come to turn signals for the U1000
all the wiring is in place. If you are doing after market you will tap in for the fronts
at the connectors. and for the backs the turn signal wires are already there next to the OEM
tail lights. You will have to remove the sides of the dump bed to get to them not to hard to do.
4 bolts and 3 screws. Use the OEM flasher and switch they plug right-in.

If it's now similar to the 2022 600 setup you don't have to take the sides off. You can reach the connector near each rear light and switch the connectors and it will start working

For the 2023 the turn signal wire is not part of the connector to the tail light
it is separate with a pin connector on it and it is ty-raped up so i had to
remove the sides of the dump bed to get to it.

Ok. 600 has the pin connector too. I had bought a Tail as Turn module based on a Youtube video and didn't need it. Unfortunately I waited to do the installation past the return deadline and have it available if anyone with the old connectors wants to buy it.

What are the part numbers needed for the turn signals on the 2023 Uforce 1000?

Flasher 5HYV-161000-1G01. Turn signal switch 5ASV-169060-6001. Hazard switch 5ASV-169090-6001

I tapped into the Orange (Drivers side) and Baby Blue (Passenger side) wires right at the connector under the bed.  I ran new wires to my 3/4" Side Marker lights I bought off Amazon and brackets off eBay.  I could have cut out the holes in the box under the taillights but decided against that.  I know some folks have tapped into the backup lights to use as signals but where I live and I'm sure it's across the country, turn signals should be Amber or Red. 

Could one of you take some pictures of the finished product?  Front, rear and switch panel?

I tapped into the Orange (Drivers side) and Baby Blue (Passenger side) wires right at the connector under the bed.  I ran new wires to my 3/4" Side Marker lights I bought off Amazon and brackets off eBay.  I could have cut out the holes in the box under the taillights but decided against that.  I know some folks have tapped into the backup lights to use as signals but where I live and I'm sure it's across the country, turn signals should be Amber or Red.

Like this???