I figured out an easy and efficient way to install turn signals on the uforce  1000. I bought the cfmoto blinker module and switch from them. I also bought some amber trailer marker lights. The module plugs in under the hood, and the switch plugs into a harness behind the dash/switch panel. I tapped into each turn signal wire before the headlight plug on their respective side. Orange wire for driver side. Light blue for passenger. And I tapped into the ground (green) wires there too. Installed the lights on the plastic front bumper cover thing.
On the rear, I took the bed off and tapped into the reverse light wires with the turn signal wires to make the reverse lights flash. Pretty easy mod for ease of mind on the road

What color(s) did you splice into for the rear backup lights?  Thanks

Yes. I actually called cf moto and the told me that for the tail lights also. You save yourself about $600 by doing that.

Yes. I actually called cf moto and the told me that for the tail lights also. You save yourself about $600 by doing that.

Did you have success taping into the tail lights for use as turn signals?

After watching various videos on ways to add aftermarket turn signal lights, here's my approach. I used all CFMoto switches and flasher unit. LED lights purchased through Amazon.com along with metri-pack type plugs. I tapped into existing wiring points for the rear turn signals by the rear light "jumpers", and for the front, I tapped into the plug going to the front lights with matching metri-pack crip blades.
Not the easiest and quickest approach but I didn't have to drill into the body.

Very nicely done!

After watching various videos on ways to add aftermarket turn signal lights, here's my approach. I used all CFMoto switches and flasher unit. LED lights purchased through Amazon.com along with metri-pack type plugs. I tapped into existing wiring points for the rear turn signals by the rear light "jumpers", and for the front, I tapped into the plug going to the front lights with matching metri-pack crip blades.
Not the easiest and quickest approach but I didn't have to drill into the body.

Any chance you may have the link for the lights you used for the rear ?

https://www.amazon.com/gp/product/B09289FX68/ref=ppx_yo_dt_b_asin_image_o05_s00?ie=UTF8&th=1

sorry didn't copy as a link

https://www.amazon.com/gp/product/B09289FX68/ref=ppx_yo_dt_b_asin_image_o05_s00?ie=UTF8&th=1

sorry didn't copy as a link

Thank you. Did you get the 3.4 or 4.4 inch ones? I haven't picked up yet or I'd measure myself

I used 3.4 for the rear and 4.4 amber for the front.

I used 3.4 for the rear and 4.4 amber for the front.

Again, thank you, Appreciate the quick response