It usually squeaks driving at low speeds. Never when I hit the brakes. I tried spraying lube all around the tires and suspension but no change. The wheel bearings are sealed and with only 90 miles I would not think it would be them. I will try to spray the pads and see if that works. Thanks for the tips.

Hello. I have 90 miles on my cfmoto 400 and I have been noticing a squeak coming from the tires. The only grease fittings I see are for the suspension. Any thoughts?

Looks like the ignition switch went bad. Poor quality for an ATV with 70 miles on it. I hope this is not going to be a machine that constantly breaks down.
Thank you for you assistance. I really appreciate all of the help gentlemen.

I really appreciate all of your help. So you want me to take a multimeter and test the outgoing wire correct? What setting should I have it on and what readings am I looking for. Once again thank you for taking so much time on this.

Can I just use a regular fuse adapter. Cut the wires and use butt connectors to attach the new adapter

I tried while it was idling to wiggle the adapter that the main fuse is plugged into. I was not able to get it to stall. I found the solenoid relay online for $25. I have not been able to find the main fuse adapter anywhere. Do you know where I can purchase it. I called the dealer and they also said there have been numerous issues with the main fuse connection.

How would I test the power coming off the main fuse wires. If it is bad is there a replacement part available. It only stalls when the ATV warms up. Then it will restart when it cools down. It has to be either the main fuse or the solenoid relay next to it. Right?

Today I turned the key and had power. I ran it for about 5 minutes and the put it in park and stepped off. Machine stalled and has no power again. Same scenario as yesterday.

I pulled the main fuse and it looks good. It appears to be secured in the adapter snug.

I forgot to mention that all the connections at the battery and the solenoid relay have been checked. I can arc power over two terminals at the solenoid relay to the starter. This does not bring power to the dashboard. When I turn the key there is nothing. My winch which is hooked up directly to the battery still functions.

I have a 2020 400cc that stalled out while idling. I turned the key to start it but there is no power. I checked the battery and it is good. The main relay and starter relay are good. All of the fuses look good. Would this issue be caused by the solenoid relay under the seat? Other than that it would have to be the ECU I think. Any help would be greatly appreciated.