on my 2024 z force 800 trail went to start it just starter click machine is brand new but has sat since february with periodic starting approx last started about 2 mos. i should of hooked up battery tender on it which i have so i charged with regular charger and took off pos and neg cables and charged for 2 hrs then put pos,neg cables back on turned key it started right up let it run when i looked at display screen i noticed efi light was on its runs fine i started a few times starts right up could this be because batt was disconnected for a few days. put battery tender on showing charged.

2024 z force trail put on battery tender charged approx 10-14 hrs i have all lights come on but starter just clicks it has sat a while since i bought it new even tried to take battery out after moving drivers seat all the way forward and removed back rest but no room to take it out plus batt is heavy so now im stuck this machine is brand new should i just keep batt tender on. any ideas how to remove batt would be of great help

on my 2024 z force 800 trail i have only started  about 5 times its been about 3 months since last starting now that its been cold in the northeast battery must be low is it okay to hook it to battery tender i didnt want to remove battery can i charge it that way through winter

on my 2024 g-2 z-force 800 trail where is best place to put jack stands on all 4 corners.

I have a 2024 z-force 800 trail g2 and would like to go with a taller tire. I would like to keep the same original wheels on it and not to add any lift kits and would like to run same size on each wheel. I like tread pattern on the tusk terra-bites! any ideas would be helpful.

thanx guys pass seat just had to lift up latch in back drivers seat is a 2 piece pull straight up on bottom seat then back straight up and out now comes fun part installing harness wish i had tiny fingers!!!!!!

Im in the process of installing harness type seat belts. how do you remove drivers side seat?

i have a 2024 z force 800 trail G-2 and want to install a set of 4 point harness to replace my factory seat belts.RNG performance had video on u tube but they had camera problems on completing install. any help on installing or pics would be greatly appreciated ! 

i just purchased a g-2 z force 800 trail i dont want to hardwire volt source what if i was to plug a 3 way cig lighter plug splitter into the 12 volt outlet on machine and use that for power source to run a led light bar,small midland 2 way radio,and maybe ablue tooth sound bar,the splitter comes with on/off switch for each outlet,obviously wouldnt be running each accessory at same time