Thank you very much for your help! I would get all different information, but not the right one! Thanks, again!!🤝🙏

NMKawierider just what i thought, that would be the oil pressure sensor. But i just can't find the coolant temperature sensor. Thought it would be located near the thermostat, but guess what...it is not...😅

Right! The only problem is that the sensor i found, has only one wire coming out of it. Where would be the other 2?

Hello everyone! So, once of a sudden my check engine light started blinking, and my cooling fan started spinning without stopping. Waited for 5 minutes, but the fan would run continuously, even with the engine cold. Scanned for the error, and i get coolant temp sensor error. Deleted the error, the check engine stopped blinking and the fan stopped. Searched for the temperature sensor and i get one with 3 pins. The problem is that, what i think is the temperature sensor, has only one wire, and one pin. Maybe i am wrong, but isn't it bolted to the engine between the two cylinders?

Thank you for your answer! When talking about the main fuse, you reffer to the 30A one, right? If so, i checked the holder with a multimeter, and i do get power from one wire to the other. Also, i checked the ground under the driver's seat, and i do have continuity

Hello everyone! I was on a ride on the trails with my 2018 zforce 1000, and right after a downhill, the engine stopped, and i get no power to the dashboard.
The battery is perfectly fine, the 30A fuse under the driver's seat is fine, all the relays in the fuse box are fine, but i get no power to the ignition switch.
When i pull out and then put back again the 30A fuse, the dashboard beeps, but it won't turn on.
The ignition switch works just fine, just that it doesn't get any power.
Does anyone have even the slightest idea what might be the problem? Thanks!