Had to remove exhaust to repair crack so instead of removing O2 sensor I unplugged it from harness when I started it the light next to P flashes . I'm guessing it's because I unplugged O2 . Wondering where the plug in for the OBD reader goes  Yes the O2 sensor is plugged back in

Does anyone know the stock clutch setting . My belt exploded this weekend and when taking the secondary apart there was tension on the spring and when I gave it a tap you might say it came alive and in doing so popped out slots so I'm not sure of the settings. THANKS

That was my thoughts

Exhaust header broke again .It broke once under warrenty and was replaced ; cracked again! What I am wondering is to remove the bolts from the head and O2 sensor should the header be cold or warm It is a 2016 z 500

Found them at a local bearing shop for about $8 . They told me they are a very common bearing used a lot on a tv 's and snowmobiles

Thanks that was a lot easier than tracing a dozen wires

Santa brought me a light bar and a 3 gang switch with volt meter . Looking for a power lead that works when the key is on . I know I could find one somewhere but some times it's just easier to ask . THANKS

They are 30mm I found one on eBay for about $15 from China of course works fine

Managed to find a number on what was left of one of the seals 6205rs which measures 25mmx52mmx15mm . Just hope I can find one at a local bearing shop tomorrow

Does any know the dimensions for the steady bearing for a 2016 zforce 500 . Dealer doesn't  have one and will be a week coming . I am leaving to go deer hunting Sat. Thanks for any input Sorry should have said for front driveshaft

My zforce is 30mm ID , found one on eBay for a canam  for about $15 seams to work fine

I guess there is difference in Canada . Dealer wanted $87 plus tax  Local Napa had to order it and had it in two days $15

Napa part #143 5040 is a direct fit and is only about $15

If you haven't done it yet take the cover off that cover the two 40 amp under the seat clean them up and add dielectric grease  or some water proof so yours won't leave you stranded like mine did . They aren't sealed very well considering there location .  Mines a 2016 force 500

Thanks that is what I was looking fot