I put it all together on bench and i can turn ckutch shaft counterclockwise but is very tough , bur it doesnt turn clockwise. Wonder if i can justvtake the grooves out with my lathe.

hey guys , so i got a new wet clutch , one way bearing , gaskets and all , got it back together and the noise is still bad and bike jumps ahead when u shift into gear. Now to confirm the arrow on one way goes to motor side or facing me. Also the clutch housing has grooves cut inside ,is this normal.

Here is another video that shows the noise it worse...

So i got it all apart and installed new one way bearing with arrow and writing facing the engine as it said, i still hav e a horrible noise coming from this thing. Onlyt hing left is the clutch pack or engine issue.

thxs for the reply, i took secondary off and reset to B1  , and its not whinnig anymore. My original issue was the bike was stuck ingear and making a really bad noise. Well i still have that noise and i got a new one way bearing and i cant seem to get the inside cvt cover off the motor. Has anyone done this before is there a trick.... thxs

hey guys , i took my clutchs apart to cleans as the bike was not shiftimg good. Now its back together and its making a very loud whining noise in forward and reverse and gets louder as you drive.. I dis take the secondary apaet and forgor to mark the spring locations. Would this cause the noise and also what is stock spring settings ... thxs