Ok, so I got it to the shop and straightened it up a little bit. Unloaded and went through the pile of plastic, seats, and misc motor parts. Most of it appears to be there. The hood is missing but I knew that when I bought it. If anyone knows where to source a hood, new or used, it would be greatly appreciated. The drive side of the engine looks like it was removed for a while and a lot of parts will need replaced on that side. I got the motor pulled today and started breaking it down. The pistons and rings looked OK and the cylinder looked good besides needing a hone. I will measure them all tomorrow to make sure they are in specs. The crank and rod bearings on the other hand are toast. Side to side paly is nominal but pulling straight up and down is clunk, clunk. Way too much play. The residual oil in the crankcase and filter was shiny, but not chunky, so that's good. I ordered a flywheel puller this evening so I can finish tearing it down. Anyway, that's where I'm at today. Any comments?
