Hi,

Yesterday I went to put my 400 in 4wd but it did not work. On the dash you can see the picture of the four wheels with the two rear lit up. When I swap to 4wd that picture just goes away. I checked the relays and swapped them around to test them out. The middle relay clicks when I move the switch so I'm guessing the switch is good. The relays seem to be good. There are three identical relays (high beams, 4wd 1 and 4wd 2) and I swapped them all around in different configurations with the same results.

Is the problem likely the actuator then? I've not been able to find confirmation that a bad actuator would make the display of the four wheels on the dash disappear?

Thanks