Thanks guys,
Very helpful, currently of to work (oil rig), but will check when i get back and let you know.

Doug,

It is getting a good 12.8v to the positive side of the trigger, but does not appear to earth through the other side of trigger. Do you know where this wire goes to?? Appears to enter loom back to ECU??
Seems to be a constant 12v to trigger and switching on Earth???
Also can't figure out why showing a 0230 code which I believe is Fuel Pump Relay ?
cheers john

Doug,

Does not appear to be a power drain on start, No power to starter motor or solenoid when playing up.
Seems to be constant power to solenoid trigger but not completing circuit when the condition is there.
Can always start by bridging solenoid.
Don't think problem is with solenoid either but whatever earths the trigger?

Well, pulled it all apart, could not find any obvious bad connection.
Put it back together and it worked fine, for two days!
Same problem, same fault code.
Bit over it, such a cramped little machine to work on and all those plastic clips give me the >>>>.

Thanks mate,
Will check this morning, battery tests OK, will have a look at fuse holder.

Hi all,

UForce 800 (2021) user here from Australia.
Bought a U800 for prospecting for gold and after only 60 kilometres has developed a problem.
Started off as an intermittent fault where it would not start (or turn over) fuel pump would come on and get pressure.
Now its full time not working.
All relays good.
All fuses good.
shows a code on blinking dash light of "P0230 FPR Coil Circuit Low Voltage or Open FPR-Fuel Pump Relay"
Fuel pump operates when key is turned on.
Do any of the CFMoto experts on here have any ideas?
Cheers,
John