Does your horn work?  This is going to sound like a weird thing to check, but I had a similar issue a few months ago and it oddly turned out to the horn fuse.  I changed the horn fuse and the pump started working again. 

Happy to report I replaced the starter last week and I am back on the trails.  Just for information purposes..  I had to remove the 3 plastics behind the seats and the cover on the emergency break oh and the rear window since it was held by the same bolts  Glad I bought a bag full of those pesky plastic clips as I think there was more of those clips than there were of bolts holding those plastics.  The starter was pretty easy to remove, just needed to unhook the two safety break cable lines and then just the 2 bolts holding the starter in place.  I did end up taking the starter apart and after a bit of frigging around got it to turn over again.  I threw it in my spare parts box and bought a new one since there was a bit of wear on the brushes so better safe than sorry.

Thanks to the forum helpers on here for the suggestions and pointers.   

Anyone know if there is an easier way to get to the starter on these darn things.  I have the plastic off behind the seats, the rear windshield off, I can now see the starter and reach it (barely).  I am now taking off the air intake hoses, hoping to be able to get my hand in there to get to the bolts.  Is there how you guys would go about it, or is there some magical trick to getting in there?

UPDATE:  Well checked the solenoid- good, check the current getting to the starter - good.  Ran a direct wire to the starter to make sure, and no good.  At this point, I am thinking it is a bad starter since I have current. 

Got the manual thanks... at least I am not blind anymore

Thanks for the reply.  I will give that a shot and report back.  Do you know if there is a relay under the driver seat or something to check as well?  I don't have the English manual.  Since I can't read chinese, I am left with a book of pictures   I assume I need to remove the front driver side wheel to get at the starter? 

I am looking for a little help.  My 2014 Snyper 600 died on me in the woods the other day.  It was working fine, but after turning it off, I tried to start it again and all I get is a click. All the board, lights winch all work.  I tried the battery just in case and fully charged, then I looked at the 5 fuses under the dash and they all appears to be fine. I noticed the fuel pump no longer engages when I turn the key now.... the fuel pump was engaging the first few times I tried, but now it is not.  Any help would be greatly appreciated as to where/what to try next.

Thanks all