The SB seems like the way to go. These have to be wired in right?

Good to know, thank you!

What length bolts did you use?

Hello,

I have a set of stock Zforce 800 Trail shocks for sale. About 750 Miles on them. A little dusty but otherwise ready to ship after a wipe down. If there is interest in these please message me!

Thanks!

Save yourself the headache and hemorrhoids, the stock springs are terrible. You'll want those bandits or elkas sooner rather than eventually haha

the machines really do tear everything up, personally we just try and ride the main trails and roads up north. is is quite dusty but probably not near as bad as you have.

Seriously impressive!, I would love to have a particle separator and setup like that. Unfortunately, my state is very restrictive with snorkels. I still want to get replace the narrow factory tube with a intercooler pipe and adapt it with silicon elbows to the plastic intake grate or figure out some other stealth solution. Kinda winging it here because anything will be an improvement over the stocker.


https://www.maine.gov/ifw/atv-snowmobile/atv/laws-rules.html

"26. Prohibited equipment. A person may not operate an ATV that is equipped with a snorkel kit or other equipment designed to allow the ATV to be used in deep water except with the permission of the owner of the land on which the ATV is operated or as provided in section 13159."

found it haha

Old post, but what length 2.5" tube you use to oval out? the links are dead

Looking to buy a kit on amazon, what did you all use? More wondering about about what length battery cable is needed.

Remember...only a quality foam filter oil treatment.

I used maxima fab1. That is some nasty stuff. I guess it was worse for me because I was doing three at a time. I had to grind off the ring on the connection between the air filter and air box on the 4 wheelers but the Zforce slide right in.

the plastic connection sucks bro, fair warning. I'll stop beating the dead horse

PJ1 is the best filter oil IMO but the UNI kit works fine and can be had for cheap on amazon.

Always keep a couple Uni's pre-oiled in seperate zip lock bags. When one is dirty, pop a fresh one on and use the bag to bring the dirty filter home to clean.

Mine just came in. I got one for each of my machines. They are pretty available on Amazon. No I just need to grab some oil and install.

Make sure to put a nice piece of pipe in there and get rid of that plastic adapter. Cut to fit. I think I did mine at 3" and used a dremel tool to take off the plastic ridge inside the intake tube.

HPS AJ400-225 6061 T6 Aluminum Joiner Tubing with Bead Roll, 16 Gauge, 4" Length, 2.25" OD, 0.065" Wall Thickness
by Amazon.com

https://www.amazon.com/dp/B014GXQ17W/ref=cm_sw_em_r_mt_dp_EZ9VMF1ED0XATAM4H4H2

Nice ride! The color is on point.

Welcome friend

Welcome!!