Has anyone else installed one of these on a U10XL? I put mine on and I feel like the wiring harness is about 8" short of what it should be. It's tight enough that I cannot secure the connection again behind the rear seat. It's just loose bouncing around right now.

What are the must have accessories for the U10 Pro XL? When it comes to the windshield I'd love to get the power flip up OEM, but is a vented windshield just as good? When I had my 2019 Force 1000 it was necessary because of the heat generated by the motor. Im wondering if a fixed windshield with vents will be sufficient on the U10?

Is your seatbelt clicked in? There is a safety feature that only lets it go so fast if the seatbelt isn't worn or at least clicked in.

Thanks for the advice. I suppose I never considered that they would fail so soon. I'll take a look at that tomorrow. The clunk is on the front passenger side.

I've noticed a clunk in the front end when I'm going over bumps. I put it up on the lift and can't seem to find anything loose. The wheel bearing seem fine, tie rod ends seem tight and all suspension connections are tight. I can't seem to find the cause of the clunk. Anyone experience this?

I don't have personal experience with this. But Main Street Cycle sells a kit for these. Comes with the Uni filter, two aerosol cans of oil and pre filters. They did right by me with the ECU Tune, I'm sure they wouldn't sell this filter kit if it doesn't fit.

I shipped it out on a Friday, I had to work all weekend anyway. They had it for two days and two days to ship it back. So my machine was realistically out of service for 6 days total. I would expect 2 days to get there, 1-2 days to flash and two days back. Probably could have it back in 5 days. I also live in northern NY so shipping times could vary.

I received my reprogrammed ECU from Main Street Cycle yesterday. I put it in the machine and much to my surprise there is a very noticeable difference in the throttle response. I could honestly care less about gaining torque and HP (but those gains are noticeable as well); I just needed the jumpy throttle issue corrected. Main Street Cycle did not disappoint. My wife finally enjoys driving and riding in the machine. If you don't mind spending a little money, this is 100% worth it. 

Shipped the ECU today. I will update with results when I get it back.

I mostly use the machine around the farm, not a terrible amount of trail riding. When I've got the family in the front and two German shepherds in the back there isn't much room for our gear when we head down to the river for the day.

I have a 2019. It did not come with a mode switch and the ECU is not programmed to accept one. So when I put the mode switch in all it does it change the icon on the dash. From what that video shows I think the folks a MSC might be able to solve this issue. We shall see if it works or if I should have just put the money in a paper shredder. I have faith though. I'll post an update when I get it back.

Thanks for the video. I was skeptical that it would actually change anything at all, just like when I wasted the $20 or whatever it was on a mode switch. But it looks like they actually have done something here. I think I'm going to take the chance and have it flashed. Hopefully it doesn't take too long to get it back, I use my machine every day.

Does anyone know where the ECU can be sent for a flash? I can't stand my throttle response.

Anyone have any suggestions on a roof rack? I was considering the hood rack but I don't think it'll work with my current brush guard.

I just installed the Rival doors on my 2019. I will say that the fit and finish of the doors is of quality. That's where it stops though. Unless you are pretty well mechanically inclined it's going to be a long day. The brackets themselves are good, the hardware acts like it's made of pot metal. I broke off a few bolts and ended up drilling and re-tapping a few holes. The directions are next to useless,simple drawings only, no text step by step. I called Rival direct at one point to get some instruction. I was told someone would call right back and they never did. This is my experience. In the end I'm pleased, but halfway through the install I was ready to ship them back.