0 Members and 1 Guest are viewing this topic.

*

Offline Cosmosdan

CV axle pulling out of differential
« on: October 25, 2016, 03:21:07 PM »
My rear axle kept popping out of the differential. So after a few choice words, OK a lot of them, I took it apart and found the snapring is a bit small and just not holding well. I could have bent it out a little bit but I had an axle for an early 2000 sportsman. I measured the ring on it. They are thicker by .010 and will fit. It was a pain getting it to go in, but after making a match mark to line it up then a few good wacks, it's not coming out without my permission again.
2013 Z6 Trail
Iron Baltic skid plates
UE Boom Speaker mount
RZR 800 Shocks
Mostly stock trail riding
25g. Rollers and A1

2016 Outlander max 570
Too new for mods yet

*

Offline NMKawierider

Re: CV axle pulling out of differential
« Reply #1 on: October 25, 2016, 04:33:33 PM »
Good. As I recall, someone else had an issue with an axle that kept coming out.
2015 Z Force 800 53/Trail EPS
Custom Air Intakes | Custom Exhaust Mod | SuperATV Harness | Custom Fenders | Custom Skid/Rock Sliders | 27" GBC Grim Reapers | Seizmik Mirrors |Конструктор Doors | Dr Pulley Sliders | 1.5" Wheel Spacers | BENZ Silencer (as needed) | SATV Flip Windshield W\ Rear Shield | Dual Light Bars | Diamond Plate Storage |7- 9.7" GPS Systems | Bandit Springs Rear & Gen-3 Shocks Front | Cage Chop Mod

My Videos On YouTube

Re: CV axle pulling out of differential
« Reply #2 on: October 25, 2016, 04:48:42 PM »
I had the issue with the axle coming out multiple times.  They eventually had to put a longer axle in.  So far so good.