CFMoto-Forum

General Category => General Discussion => Topic started by: thewind60 on April 01, 2016, 10:36:07 AM

Title: Zforce motor Vs can am outlander motor
Post by: thewind60 on April 01, 2016, 10:36:07 AM

hi
i saw that the CF moto is look almost the same as the can am outlander motor.
anyone can tell if the motor are similar? are the parts from the Can-Am can fit the CF?
Thx!

Title: Re: Zforce motor Vs can am outlander motor
Post by: NMKawierider on April 01, 2016, 10:46:37 AM

Quote from: thewind60 on April 01, 2016, 10:36:07 AM

hi
i saw that the CF moto is look almost the same as the can am outlander motor.
anyone can tell if the motor are similar? are the parts from the Can-Am can fit the CF?
Thx!

The basic design was a copy of the Rotax 800 but many little changes makes most parts not work in it. Others will chime in to confirm though.

Title: Re: Zforce motor Vs can am outlander motor
Post by: emersonsc on April 06, 2016, 08:44:33 AM

Connecting rods on the CanAm are shorter. Wrist Pins on the CanAm are smaller. Pistons are different. Crankshafts are different (this is mostly to do with CFMoto using a wet-clutch system). Then the cases are modified to house the wet clutch itself.

They are similar, but very different at the same time.