[dogface]

hey new hear i just bought. a cforce 800ex been plowing snow here in new England this atv is a snow pushing beast only problem is i broke the winch cable lifting plow to high it is hard to tell when plow is all the way up and yes i have a rubber bumper on it so my question is has anyone installed an auto winch stop from Kolpin on a cfmoto if so did the wiring plugs hook up ok 

[Ulfthednar]

practice.
cheaper than the auto kit.
What I do suggest if you didnt get one is their pulley system

We are using an 800xc at work (ski resort) with a plow and we were regularly breaking cables to.

The boss ordered us a pulley kit and it changed the whole dynamic of the plow.
We get better lift, it doesnt drag the machine down as hard when you lift the plow and gives you a good bit more room.
We also swapped it over to a hawse fairlead and synthetic rope.

The pulley kit has a pulley fairlead, a single pulley block that attaches to the plow and a strap you wrap over the bumper or rack and hook to.
Haven't broken a cable since.
Took me about 20 minutes to swap it out (having never seen one before) and set it up. It's also got greaseable pulley hubs.

My experience with the synthetic rope encouraged me to swap mine over as well, though I have a small tractor for plowing instead.

[dogface]

I had the fairlead with the pully on still brock the cable so i did bye the koplin auto stop fairlead took a bit to install it but very happy with it stop wear ever you set the magnet to on the rope