0 Members and 1 Guest are viewing this topic.

*

Offline NMKawierider

Re: Secondary Clutch Removel Question
« Reply #45 on: September 20, 2015, 09:56:16 PM »
I have a question about the sliders. I know they are supposed to increase your top end. Do they change your bottom end any. I don't want anything that will increase my starting ratio. I need it as low as possible for mud tires and the rough terrain around here.
They go a little lower and higher on the ramp so you get a little lower starting ratio and end with a little more top end. It isn't much but enough to feel. If you go to the Dr. Pulley website, they have a video showing this.
2015 Z Force 800 53/Trail EPS
Custom Air Intakes | Custom Exhaust Mod | SuperATV Harness | Custom Fenders | Custom Skid/Rock Sliders | 27" GBC Grim Reapers | Seizmik Mirrors |Конструктор Doors | Dr Pulley Sliders | 1.5" Wheel Spacers | BENZ Silencer (as needed) | SATV Flip Windshield W\ Rear Shield | Dual Light Bars | Diamond Plate Storage |7- 9.7" GPS Systems | Bandit Springs Rear & Gen-3 Shocks Front | Cage Chop Mod

My Videos On YouTube

*

Offline Cosmosdan

Re: Secondary Clutch Removel Question
« Reply #46 on: September 20, 2015, 10:54:27 PM »
Dr pulley states that they increase lower and upper with no top end loss with weight up to 1g lighter than stock. I did see a slight improvement at 24g. Others have tried increaseing the secondary spring tension with good results. I'm sure they will chime in.
2013 Z6 Trail
Iron Baltic skid plates
UE Boom Speaker mount
RZR 800 Shocks
Mostly stock trail riding
25g. Rollers and A1

2016 Outlander max 570
Too new for mods yet

Re: Secondary Clutch Removel Question
« Reply #47 on: September 21, 2015, 06:48:57 PM »
Thanks guys. I just didn't want a higher starting ratio. A lower ratio would be great.
2015 ZForce 800EX EPS
Two Bros. slip-on
Snorkels
Half windshield
30" Monster mayhems on STI HD2s
2" lift
Secondary clocked to C4
1mm Primary Shim 3.25:1 Lowest Ratio
More to come