[MTRIDER]

So.. on front of my 2020z there is a plugged connector, and in the glove box a connector that plugs into it.. one power wire one ground I assume (green and black) I plugged it in and didn't seem to get power off any of the wires when i turned on lights.. is this for the after market turn signal kit I'm guessing.. was hoping it was for maybe a light bar and was thru a light switch.. lol

[MTRIDER]

So.. on front of my 2020z there is a plugged connector, and in the glove box a connector that plugs into it.. one power wire one ground I assume (green and black) I plugged it in and didn't seem to get power off any of the wires when u turned on lights.. is this for the after market turn signal kit I'm guessing.. was hoping it was for maybe a light bar and was thru a light switch.. lol

[NMKawierider]

Usually those extra connections are for factory turn signals. With the wiring diagram you could trace the colors and see. If you want one just let me know..

[MTRIDER]

Thx.. yea.. noticed u have two in glove box.. cyz theres one on each side of the front of machine

[NMKawierider]

Thx.. yea.. noticed u have two in glove box.. cyz theres one on each side of the front of machine

Well, there would need to be a place to plug in the relay/flasher and one for the switch.

[doug80638]

Unless they changed it for 2020 (which I doubt)

The relay is likely already installed (I've yet to hear of on that wasn't).

And the wiring is already under the dash for the rockers (signals/hazards).

It's all plug-n-play.