[Gordhead]

I cannot start my 2013Snyper 600 with the key. All I get is a clicking from the solenoid! I can start it by jumping the solenoid no problem! I changed out the solenoid and it still won't start! Any ideas?

[NMKawierider]

I would say either you are not getting 12 volts to the solenoid from the key or there is a bad ground.

[Cosmosdan]

I would think that if it's clicking that the trigger is ok,but I've been fooled before. Bridging the solenoid and it starts fine makes me think the battery is ok too. I would check the ground like NMK said. I recall it is close by the battery. The solenoid might not be getting good enough voltage at the trigger to work right.

[NMKawierider]

Yeah if you jumper the battery post to the trigger post and it engages but not with the key, there is something up with the trigger wire circuit. I find that there are some connectors that don't fit well and cause voltage loss through the connector. I still have one I need to fix...someday

[Gordhead]

Thanks guys, must go out and check the wiring & grounds!