[WalkinTarget]

Likewise !! I had a major upgrade a few weeks back and added Bandit springs to my ride. No more sage from the crappy Arctic Cat springs !! I went from 8" of GC to 14" (!!) so I had to dial it back a bit - the guy who did the work for me cranked the hell out of the springs so I had him lower them to a more reasonable 12" of GC. I'd still like the extra 2" provided by a bracket lift, but to be honest, a 3" increase in my width would now be a more practical upgrade.   

[cfmotoz8002015]

  very interested!!
I was disappointed when I saw the a-arm kit from super lift come out and found out it's only for the EX! 
Like to see one of those kits as well for a regular z800 and 53.

[mayor hal]

very interested!!
I was disappointed when I saw the a-arm kit from super lift come out and found out it's only for the EX! 
Like to see one of those kits as well for a regular z800 and 53.

Me too!

[cfmotoz8002015]

I'm interested!!! How much?
Any progress??

Me and my friend are fabricators and was considering making a laser cut 2 inch lift for the cfmoto zforce 800 and probably for the uforce. Would there be a lot of interest?

[cfmotoz8002015]

Where are we with these and how much for a 2015 zforce 800esp. I'd be willing to test out on my machine. Let me know, message me. Thanks

[cfmotoz8002015]

Following up again on these... how did they come out? Still interested! Message me I'd like to get the ball rolling on this lift. Thanks!

[cfmotoz8002015]

Dead post...