[campermac]

Looking to see if anyone has information on the wheels on a 2024 Uforce 600.
I am looking for the offset of the wheels.  My dealer can't seem to be able to get the info for me and several other dealers I checked didn't know either.
I want to put aftermarket wheels and tires on my machine and do not want them to stick way out.

Any help would be appreciated.

[NMKawierider]

The inset and width are either stamped or cast on the back side of the wheel. The offset will be in millimeters. Take those two numbers and use any of the on-line converters to find the inset of the wheel. The balance of the wheel width will be the outset. It will not be an even number like 4+2 or 5+2 but you will have the factory offsets to go by.

My rear wheels for example are 8"s wide and have an inset of +46.5 mm. That converts to 6.33 so taking that from the 8" leaves 1.67 so my rear wheels have an offset of 6.33+1.67. The closest to stock I will find would be 6+2..but I have never see that offset for an 8" wheel so either I go with a 7 or add a little width and go with 5+3.


 

[campermac]

That makes sense.  I was told that they were 5+2 but I wanted to confirm for sure. 

What size tires are you running?

[NMKawierider]

That makes sense.  I was told that they were 5+2 but I wanted to confirm for sure. 

What size tires are you running?

I run 27x11x14s on the back and 27x9x14s on the front. Still using the stock wheels with 1.5" spacers although before I bought the tires I had the same 11s and 9s on my Brute in a 26" all on a 5+3 wheel and they worked fine...except the 9s on an 8" wheel isn't the best choice. Should have been a 7".

There were the test tires and wheels I put on the Z.


And this was the test video I did way back in 2015.