to Swap a 950 engine into a Cforce 800XC frame (same frame as the 1000)
The cases are the same, so The correct control module, the intake from a 1000 should work and maybe the 02 sensors if theyre different from the 800.
besides plugs, injectors etc . .


thoughts?

[2015 Z Force 800 53/Trail EPS]

Dimension-ally they are the same and likely the same mounting points so it will bolt in. You could also put the 1000 top-end on the 800 as well. Control systems are slightly different but nothing that can't be overcome. It is likely it would run just fine with the 800's ECU and sensors.

A while back I was talking with my builder on..when/if the time came, dropping a complete 1000 top end on my old 800. Their investigation came back with nothing that would stop us from doing it other then some case adjustment for the larger sleeve. They did suggest I use the 1000's TB and intake as well as an aftermarket exhaust system. Not at all mandatory. But everything else I "could" use as is.     

Throttle Body . . of course, lol . . knew I was forgetting something in there somewhere.