Made some lightweight doors for my Uforce 1000.  Wanted to keep weight down, as this is over-snow vehicle that relies on lower weights for performance.  Also wanted to not spend a bunch of $$.

Contruction is 1" XPS foam sandwiched in fiberglass with epoxy resin.  Then cheap clear vinyl with velcro windows.  I designed/3D printed some. basic door latches.  Door attached to frame with a couple basic hinges, had to drill some holes in roll cage.  Total cost of about $150.  Most of the time was spent getting the foam to fit inside the door dimensions perfectly.  Was a tedious process for door #1, then trace/repeat for door #2.  Doors are probably under 5lbs each.

[2015 Z Force 800 53/Trail EPS]

Looks good. Nice work.

These are amazing

Looks amazing......nice job !!

Wow great looking machine!!

Your doors are spot on amazing work!

Nice job.