Hi,

Just disassemble the Rear Hub from a Cforce 850XC from 2022, and the bearings are over so need to change them, but they are two conical and the parts manual mentions one straight bearing, can anyone advise on this??

Here's the photo

Thank you

[2015 Z Force 800 53/Trail EPS]

You have my response on the other forum but in short I believe someone modified it with these bearings..bearings that were not intended for this application...an application that requires not only sealed units on both sides, but that the torque of the axle nut must transfer it's force through the hub, through the inner bearing race to the back flange of the axle. Not possible with these conical-type bearings. I would get the right ones and hope the PO hasn't done any extra machining.   

You have my response on the other forum but in short I believe someone modified it with these bearings..bearings that were not intended for this application...an application that requires not only sealed units on both sides, but that the torque of the axle nut must transfer it's force through the hub, through the inner bearing race to the back flange of the axle. Not possible with these conical-type bearings. I would get the right ones and hope the PO hasn't done any extra machining.

Yes, i saw it and thank you for the help.

Already ordered the right ones, will remove these and check for measures inside.