CFMoto-Forum
CForce => CForce 800, X8 => Topic started by: Aquaman on November 09, 2016, 07:47:09 AM
-
Hello all, I'm having a problem with my 2015 CForce 800. I'm losing my power steering intermittently and the EPS light flashes at the time. I've tried and unplug battery so the codes reset but it's still happening. Any help would be appreciated. thanks
-
Hello, with ignition on count the EPS flash, there should be long and short flashes with his will give us a code of the malfunction, check the manual on EPS and tell us which number you get?
-
I will take a look tonight when I get home. It's really strange because sometimes it is working and then it stops
-
I took a look and I'm getting error code 32. Do you know what this is?
-
17 TROUBLESHOOTING Trouble code:P0032/P0038:Heater coil high voltage of Cylinder 1 and 2 oxygen sensor
Possible causes
1)Open circuit between ECU and oxygen sensor C
pin
2)Open circuit between main relay and oxygen
sensor C pin.
3) Open circuit between oxygen sensor C and D pin
Checking procedures
1)Measure resistance between ECU pins and oxygen
sensor C pin, check if it’s ok.
2)Measure resistance between main relay and oxygen
sensor D pin, check if it’s ok.
3) Measure resistance (9.6KΩ) between oxygen sensor C
pin and D pin.
-
So this would cause a power steering issue??
-
Hello if you read the code correctly, 32, it is the Motor power-assistance abnormal, only solution or recommendation is(ECU)Check and fix motor wiring contact status, If still not work, replace EPS ECU. Also check for other post here about some EPS ECU where there was some malfunction connection inside de ECU, wiring problem, water, oxidation inside plugs and burning components on the ECU Board.