On the waterpump housing there is a fitting at the bottom with a clear hose attached to it. Other end of hose sits couple centimeter higher and open in end, to what purpose i am not sure...maby to lead out overpressure. In my case this hose got a hole in it where it goes outside the fitting and coolant leaked out. I cut the hose about 2cm(1inch) and put it back on. Anyone else had this issue? Want to replace this to something of better quality to prevent this reoccuring in future.

[2015 Z Force 800 53/Trail EPS]

Long as the weep chamber drains if either seal leaks and no fluids build up its OK. Mine has no hose on it but if I was going in water and mud I would tap for the fitting and put a short line on it facing down to drain...and a Kawasaki atmospheric check valve on the end like my Brute has. I think it's wrong to point the end up as it will have to fill the weep chamber first before overflowing. It will also hole the leakage in and take-out the seals in time. But they still make them that way...whatchagonado.