« previous next »
Pages: [1]   Go Down

0 Members and 1 Guest are viewing this topic.

*

Offline Photogrfu

Flashing EPS light. Code 32
« on: May 07, 2018, 09:27:28 AM »
My 500 HO EPS stopped working. Light is blinking code 32. Says reinsert power wire to motor. Where is the harness located? Anyone done this before?
Logged
*

Offline NMKawierider

Re: Flashing EPS light. Code 32
« Reply #1 on: May 07, 2018, 09:42:11 AM »
It just means main power to the unit is off-line. Check the EPS fuse first, then just start at the EPS motor and trace back the wires to the first connector. Take it apart, flush it with contact cleaner and inspect, then re-connect.
Logged
2015 Z Force 800 53/Trail EPS
Custom Air Intakes | Custom Exhaust Mod | SuperATV Harness | Custom Fenders | Custom Skid/Rock Sliders | 27" GBC Grim Reapers | Seizmik Mirrors |Конструктор Doors | Dr Pulley Sliders | 1.5" Wheel Spacers | BENZ Silencer (as needed) | SATV Flip Windshield W\ Rear Shield | Dual Light Bars | Diamond Plate Storage |7- 9.7" GPS Systems | Bandit Springs Rear & Gen-3 Shocks Front | Cage Chop Mod

My Videos On YouTube
*

Offline Photogrfu

Re: Flashing EPS light. Code 32
« Reply #2 on: May 07, 2018, 10:02:39 AM »
Where is the fuse?  I don't see an EPS fuse in either fuse box? Inline?  If so do you know where?


Quote from: NMKawierider on May 07, 2018, 09:42:11 AM
It just means main power to the unit is off-line. Check the EPS fuse first, then just start at the EPS motor and trace back the wires to the first connector. Take it apart, flush it with contact cleaner and inspect, then re-connect.
Logged
*

Offline NMKawierider

Re: Flashing EPS light. Code 32
« Reply #3 on: May 07, 2018, 10:55:18 AM »
Most because of the power requirements of the EPS don't run the supply through the fuse block. Rather they use a separate fuse all by it's self off of the battery. Control power is still through the system though. Start at the battery and work forward. Get the manual. It will help.
Logged
2015 Z Force 800 53/Trail EPS
Custom Air Intakes | Custom Exhaust Mod | SuperATV Harness | Custom Fenders | Custom Skid/Rock Sliders | 27" GBC Grim Reapers | Seizmik Mirrors |Конструктор Doors | Dr Pulley Sliders | 1.5" Wheel Spacers | BENZ Silencer (as needed) | SATV Flip Windshield W\ Rear Shield | Dual Light Bars | Diamond Plate Storage |7- 9.7" GPS Systems | Bandit Springs Rear & Gen-3 Shocks Front | Cage Chop Mod

My Videos On YouTube
*

Offline Z8rider

Re: Flashing EPS light. Code 32
« Reply #4 on: May 07, 2018, 03:09:29 PM »
Very early 500HO eps had the fuse in the small black fuse box. 2016-ish and newer, there will be a inline fuse with one end connected on the battery side of the starter solenoid (under seat, left side frame rail)
Logged
*

Offline Photogrfu

Re: Flashing EPS light. Code 32
« Reply #5 on: May 07, 2018, 04:16:45 PM »
Quote from: Z8rider on May 07, 2018, 03:09:29 PM
Very early 500HO eps had the fuse in the small black fuse box. 2016-ish and newer, there will be a inline fuse with one end connected on the battery side of the starter solenoid (under seat, left side frame rail)


Thank you!
Logged
*

Offline Photogrfu

Re: Flashing EPS light. Code 32
« Reply #6 on: May 09, 2018, 07:45:54 PM »
Quote from: Photogrfu on May 07, 2018, 04:16:45 PM
Quote from: Z8rider on May 07, 2018, 03:09:29 PM
Very early 500HO eps had the fuse in the small black fuse box. 2016-ish and newer, there will be a inline fuse with one end connected on the battery side of the starter solenoid (under seat, left side frame rail)


That fuse was fine. Tested for power going into the ecu and that was fine. No power going out. Ordered a new ECU
Logged
Pages: [1]   Go Up
« previous next »