What/where is the best way to add rocker switches on the dash of a 2017 zforce 800ex. I bought a winch and stereo rocker switch. Tried to remove the switch panel (removed the two front and bottom screws but panel still won't come out)

Thanks for the help

[2015 Z Force 800 53/Trail EPS]

What/where is the best way to add rocker switches on the dash of a 2017 zforce 800ex. I bought a winch and stereo rocker switch. Tried to remove the switch panel (removed the two front and bottom screws but panel still won't come out)

Thanks for the help

There are I think two blanks already in it. Just pop the plugs out and install there. Wire from underneath or pull the storage tray out from the hood and go in that way. If not those two use one of the plugs to mark another spot for a switch after confirming nothing behind it. Use a multi-tool to cut the piece out. Piece of cake- I have them all over as well as USB ports for cameras, GPS..and other stuff.

Thanks All my slots are used hard to tell where swithes will fitin the dash

I thought about buying one of these and expanding a bit.

https://www.ebay.com/itm/5P-Gang-Laser-Rocker-Switch-Panel-Patrol-Mounting-Holder-Hosing-ARB-Carling-Car/222678563236?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2060353.m1438.l2649

[2015 Z Force 800 53/Trail EPS]

I thought about buying one of these and expanding a bit.

https://www.ebay.com/itm/5P-Gang-Laser-Rocker-Switch-Panel-Patrol-Mounting-Holder-Hosing-ARB-Carling-Car/222678563236?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2060353.m1438.l2649

On that one looks like you still need to cut-out a big hole in the dash somewhere. Not sure there is that much room anywhere. How about a panel that mounts below somewhere. Maybe not this one...but something like it:

https://www.amazon.com/80-Amp-Switches-LED-Backlit-Automotive/dp/B07M9X7N74/ref=sr_1_5?crid=1L9E2FC0OSKEP&dchild=1&keywords=dash+mount+rocker+switch+panel&qid=1600273984&sprefix=Dash+mount+rocker+switch%2Caps%2C230&sr=8-5

Agree, but there are 5 existing toggles on the bottom of the dash.  Cutting a big hole might actually give you space for 7 of those toggles (they are expandable), and then having the hole would give you room to get your hands in there to get the wiring squared away.  Just a thought.  I haven't done it, yet, but that was something I was considering.

[2015 Z Force 800 53/Trail EPS]

Don't know of this helps at all but when I was looking behind the dash for places for switches and things I found some areas that were open enough to install switches and stuff that had depth less then 2" or so. I marked them on photos so in case I needed it later. Some you can get to from underneath, some from behind the storage tray after removal...some..like over the steering column I don't know.  Anyway I did use some spots.

Here's what I did