« previous next »
Pages: [1]   Go Down

0 Members and 1 Guest are viewing this topic.

*

Offline ACIDICJO

Red light on dash
« on: July 18, 2015, 09:59:12 AM »
Is anyone else besides me having an issue with this red light on your dash coming off and on from time to time?

I went into some water that was deeper then it looked and flooded it. It turned right back on and I did the necessary oil changes. The Z8 rides perfectly fine, but it's still coming on randomly. Not sure what to make of it. Any thoughts?
Logged
2014 ZForce 800 EX
14 in ITP Hurricane's
Sedona Mudder InLaws 30's
2 inch lift
24 inch light bar
2 cube lights
6 inch rear light bar
Wetsounds stealth 10 soundbar
BlueSea Fuseblock
2012 Polaris Rzr 800 all black
2005 Honda Rincon gone but not forgotten
*

Offline Cosmosdan

Re: Red light on dash
« Reply #1 on: July 18, 2015, 04:44:22 PM »
If it is the mil light and blinking, than there is a fuel fault. On constantly than  it is a uncleareed/stored fault. The service manual calls for a PDA to pull the code. I have not used this scanner before so I can't be much help. Might have to stop by a dealer to make it go away.
Logged
2013 Z6 Trail
Iron Baltic skid plates
UE Boom Speaker mount
RZR 800 Shocks
Mostly stock trail riding
25g. Rollers and A1

2016 Outlander max 570
Too new for mods yet
*

Offline bezerk1

Re: Red light on dash
« Reply #2 on: July 24, 2015, 09:14:15 AM »
Does the ZForce have and ODB2 port like a car or truck where a scanner can be attached?
Logged
*

Bpraim

Re: Red light on dash
« Reply #3 on: August 13, 2015, 11:37:53 PM »
No the Z8 doesn't use ODBII
The light you see on is the EFI sysytem and code reference light.
You can grasp the code by turning key to start position but not firing engine. count the blinks
I'm guessing as you have the light coming intermittently that its a bad connection, or a unhappy sensor.

Logged
Pages: [1]   Go Up
« previous next »