[Tecno69r]

Is there a way to adjust the factory half doors latch? The driver's side is perfect but the passenger side has a rattle and lots of play.

[Stovtop]

I have not found any way to really adjust it to make it tight enough so it doesn't rattle (both my doors rattle terribly) but what I did was put some thick foam tape on the door kind of where the loop catches and it adds some tension and stops the rattling quite well.  Once and a while I blast them off with the pressure washer and just throw new ones on.

[Tecno69r]

I have not found any way to really adjust it to make it tight enough so it doesn't rattle (both my doors rattle terribly) but what I did was put some thick foam tape on the door kind of where the loop catches and it adds some tension and stops the rattling quite well.  Once and a while I blast them off with the pressure washer and just throw new ones on.

Ok thanks. That's what I figured after looking at it for awhile. Was hoping there would be some adjustment on the post. I have the Super Atv lower door inserts and was going to put rubber kits on them anyways to give a better seal.  That will probably get rid of some of the rattle.

[JamesDEvans]

Is there a way to adjust the factory half doors latch? The driver's side is perfect but the passenger side has a rattle and lots of play.

The latches are adjustable in the door, they slide forward and back. The catch is adjustable as well, it slides left to right (towards inside and outside) of machine.

[Bobcat 72]

Had to take both doors apart and retighten latches to stop the rattle.