[Bsmith]

The red  Injector light on the dash is blinking,  Sometimes it will stop and start other times it will just continue to blink and roll over, Anyone else had this issue or know a good starting point

[NMKawierider]

The red  Injector light on the dash is blinking,  Sometimes it will stop and start other times it will just continue to blink and roll over, Anyone else had this issue or know a good starting point

Well, it has an error code so just grab the service manual, get the code, and start checking it out. May just be a bad connection or sensor somewhere.

[Bsmith]

I was not aware the service manual would tell you the codes like that I'll have to see what section that's in

[NMKawierider]

I was not aware the service manual would tell you the codes like that I'll have to see what section that's in

The codes are on 11-28. The procedure to read them is prior.

[Bsmith]

I grounded pin 26 in ecm, couldn't get flash code, tried 8 or 9 times,

[doug80638]

If it is already blinking, then is is likely blinking the code.

Count the blinks between pauses.

[Bsmith]

Just continues to blink but no pause for a code

[Bsmith]

Pin 23 is batt+ shouldn't that be hot even w ecm unplugged?

[Bsmith]

Got it to run by tapping a relay, still sent havd my power wires at ecm, 23 hot at all times?, other power wires like to ignition is that 12 or 5v