I really would like to add a glove box in my Z6. It looks like the box for a Z8 would fit. They share the same front plastics so I am guessing that it should work. They don't have it as a complete assembly so I would have to order all the parts and put it together. Total cost is about  $100 usd

Do the Z6's not have any kind of storage compartments in the cab?

Cup holders, that's it.

Did you ever try adding the glove box?

Too broke to try it now. I looked into it and you would have to buy all the parts separate and put it together. Came to just over $100. Still not 100% sure if it would work, but it should.

Looks like the new z5 or 550 has a glove box. I have not been able to check the part numbers yet but it might be the same as well. I was on the fence about selling the SxS for a 2up but I will keep it for now. I think a glove box will be great and I will have to give it a try.

I found a used Z8 glove box on ebay. I think it's time to try to see if I can make this work. Just waiting on our friends in the north to ship it. I will do a how to if it works out.

[2015 Z Force 800 53/Trail EPS]

Can never have too much storage. It'll make a nice addition.

If I can fit it up i'm going to use something to make it more water tight and add a usb power port in there for a safe place to charge the phone.

I put that foam/rubber seal with the sticky back around the "bead" inside and it stays water tight.

How wide did you use? I will definitely be doing this

I think 1/2" , I'll check and post a pic.

Found the pic I took, thought I did when I put did it.

Thanks

OK I have the glovebox now. And I have some questions. It's not going to be easy getting it to fit. The front looks the right shape but the back hits the firewall and  in a few other spots too. Heat gun and some shaping are called for.
Questions
1. Where does the rubber latch mount. Mine doesn't have one.
2. There are 3 studs with nuts on top. How does it mount. Even with a bracket, how do you bolt it in.