Hello, So my uncle has a 2013 CfMoto Z6 600, It was sitting for a while and I've started fixing it and got it to the point where i could get it started, (Kinda), the only way id get anything to turn in the motor is to jump the solenoid which i know its probably not a good thing but, i got a new key switch for it checked over everything to make sure it all works, and after putting the key switch in I've gotten no power or response from the key switch, The dash panel doesn't turn on and the ECU doesn't have issues. I also checked through the wiring and found no fowl play, and im in need of a bit of help, would anyone know why this is happening? And part of me thinks its a bad Kill switch but it doesn't seem to be the issue. any tips?

[2015 Z Force 800 53/Trail EPS]

Although the kill switches are a problem on most because they are not waterproof, they don't stop the dash lights from coming on, just the fuel pump and ignition. Sounds more like another old problem CFM had with the main fuse. There was a point when they used a glass-type fuse and they always either corroded or blew. Check it. It will be close to the battery. Next if there is power to the key switch then there may be a bad AUX relay. I have a service manual for the Z6 and I think..not sure..but I think they were putting the wiring diagrams in them back then. I will PM you a link.

Thank you for the info ill come back here if I have the same issue or if something else comes up.